storekit

Included in kit: 

 -Base
 -Front
   -Back 
  -Left side (no windows)
  -Right Side (windows)
  -Roof
  -Two architraves (pieces for the top of the roof)
  -Two signs (more can be ordered @3.40 ea)
  -Plexiglass for roof and windows
  -Two Door handles

Note that the base has pre-drilled holes and the front, sides and back have corresponding holes.  This sure simplifies putting the kit together!
-Put LEFT side in place, matching pegs to holes

-Put BACK in place, matching pegs to holes

-Using Masking Tape, tape the left side to the back and tape both pieces to the base.

-Put Right side in place, matching pegs to holes (this is the piece with windows, no door)

- using masking tape, tape right side to the back and to the base.

-Put FRONT in place, matching pegs to holes

Using masking tape, tape the front to the sides and to the base

Put SIDE ARCHITRAVE in place matching pegs to the holes

Using masking tape, tape the arhitraves in place

Push the two door handles in place

There’s a peg on each of the signs.  You will have to decide where you would like them placed.
Place the sign under the CAPITAL and to the side of the PILISTER, and make a pencil mark where the peg reaches.  This is where you will have to drill a hole.

When you have finished your trial assembly, decide on the colors you’d like your store to be, and how you would like to finish it.
Remove the masking tape and do all your painting, wallpapering and finishing, both inside and out, then re-assemble as per the above steps, but this time, apply glue to the pieces.  Using the Green or Blue Builders tape, re-tape, using the tape as a clamp until the glue dries. (The Builder’s tape will hold, yet not remove any finish when removed.

Applying Siding

FINISHING STORE IN WOODTONES